Maytag MBF2254HEW Use and Care Guide - Page 5
Drawer - model
View all Maytag MBF2254HEW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
3. Usinghexheaddriver,turn the frontadjustment screws(A}on eachsideto raiseor lowerthe front of the refrigerator. Door and Drawer Removam Some installations require door/drawer removal to transport the refrigerator to its final location. IS IS Some models only have adjustment screws "A_" 4. Select models also have rear adjustment screws (B}. Using the hex head driver, turn each of these adjustment screws (B} to raise or lower the rear of the refrigerator` 5. Using the carpenter's level, make sure front of refrigerator is '/4" (6 ram} or '/, bubble higher than back of refrigerator and that the refrigerator is level from side to side. 6. Turn stabilizing legs (C} clockwise until firmly against floor` 7. Freezer drawer models only: Turn adjustment screws (A) counterclockwise to allow the full weight of the refrigerator to rest on the stabilizing legs. 8. Replace bracket cover(s}. Position cover into the outer edge of the hinge. Swing the cover toward the cabinet and snap it into place. 9_ Replace the toe grille. . For proper reinstallation, ensure the "top" marking on the interior of the toe grille is oriented correctly. Align the toe grille mounting dips with the lower cabinet slots. Push the toe grille firmly until it snaps into place. Unplug power cord from power source. 2_ Remove toe grille and bottom bracket cover(s} (see page 3}_ Remove top hinge cover from refrigerator door by removing Phillips screw and retain screw and cover for later use. Unscrew _,_" hex head screws from top hinge to remove hinge and retain ,_. all screws for later use. 5_ Lift refrigerator door from center hinge pin. 6_ For swing freezer door modems onmy: Hold freezer door while removing hinge pin with a _" hex head driver. Remove door from bottom hinge and retain hinge pin for later use. }:or pullout fteeTet drawer modems onmy: Remove plastic sleeve, if present. Remove center hinge pin with a _,_" hex head driver, Retain hinge pin and plastic sleeve for later use. Remove Phillips screws to remove center hinge and retain all screws for later use. 8_ Remove bottom hinge or stabilizing bracket with %" hex head driver and _.retain screws for later use. Lift out bottom hinge pin (on freezer door models}. 9_ If your model has a pullout freezer drawer, see page 5 for drawer removal instructions.