Maytag MDB7949SDZ Use & Care Guide - Page 7
STEP 4, Select a Cycle, Select Options, Follow the Progress of the Dishwasher, STEP 5, Start or
View all Maytag MDB7949SDZ manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
STEP 4 Select a Cycle Efficient dishwashers run longer to save water and energy, just as driving a car slower saves gas. Cycle times may increase or decrease depending on selections. Estimated cycle times after calibration are listed in the "Cycle and Options Descriptions" chart in the following section. Select the desired cycle by pressing the Cycles button. Each time you press the Cycles button, it will advance to the next available cycle. Select Options See the "Cycle and Option Descriptions" charts in the following section. You can customize the cycles by pressing the options desired and pressing Start/Resume. NOTE: To repeat the same cycle and options used previously, press START/RESUME twice. Follow the Progress of the Dishwasher Progress can be followed on the status display and by an indicator light on the front panel. The status display will glow for Wash (A), C Dry (B), Lock (C), Sanitized, or Clean. It will also show the estimated remaining time for the cycle in hours and minutes. AB When delay is selected, the status display will show an "H" for hour and the number of hours to delay. On models with top controls, an indicator light on the front of the door panel will glow green when a cycle is running and turns off when the cycle is complete. STEP 5 Start or Resume a Cycle ■■ Run hot water at the sink nearest your dishwasher until the water is hot. Turn off water. ■■ For best dishwashing results, water should be 120ºF (49ºC) as it enters the dishwasher. ■■ Press START/RESUME button. On top control models the door must be firmly closed within 4 seconds of pressing Start/Resume. If door is not closed within 4 seconds, the Start button light will flash, an audible tone will be heard, and the cycle will not start. IMPORTANT: After a cycle is started (even if Delay Hours has been selected), if the door is open longer than 3 seconds, the LEDs will flash and an audible tone will sound to signal that you must press the Start/Resume button again to resume the cycle. 7