Maytag MER6741BAS Use and Care Guide - Page 17
Cleanln
UPC - 719881172071
View all Maytag MER6741BAS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Cleanln Self=Clean Oven (Lower Oven Only) The self-clean cycle uses above-normal cooking temperatures to automatically clean the oven interior. The oven should be cleaned regularly by wiping up spillovers to prevent excessive smoke and flare-ups. Do not allow a heavy build-up of soil to accumulate in the oven. During the cleaning process, the kitchen should be well ventilated to get rid of normal odors associated with cleaning. Before Self=Cleaning 1. Turn off the oven light before cleaning. The light may burn out during the clean cycle. 2. Remove broiler pan, all pans, and oven racks from the oven. The oven racks will discolor and may not slide easily after a self-clean cycle if they are not removed. . Clean oven frame, door frame, area outside of gasket, and around the opening in the door gasket with a nonabrasive cleaner such as Bon Ami* or detergent and water. The self-cleaning process does not clean these areas. They should be cleaned to prevent soil from baking on during the clean cycle. (The gasket is the seal around the oven door and window.) 4. To prevent damage, do not clean or rub the gasket around the oven door. The gasket is designed to seal in heat during the clean cycle. 5. Wipe up excess grease or spillovers from the oven bottom. This prevents excessive smoking, flare-ups or flaming during the clean cycle. . Wipe up sugary and acidic spillovers such as sweet potatoes, tomato, or milk-based sauces. Porcelain enamel is acid-resistant, not acid-proof. The porcelain finish may discolor if acidic spills are not wiped up before a self-clean cycle. To set Self=Clean: Note: Oven temperature must be below 400° F to program a clean cycle. 1. Close the oven door. 2. Press the Clean pad. , CLEAN flashes in the display. If the door is not closed within 25 seconds, the self-cleaning operation will be canceled and the display will return to the time of day. 3. Press the More+ or Less= pad. , MEd for medium amount of soil (:3hours) appears in the display. If the door is not closed, DOOR will appear in the display. After 45 seconds, three beeps will sound, the self-cleaning operation will be canceled and the display will return to the time of day. 4. Press the More+ pad twice for heavy soil (4 hours). , HVy will be displayed. Press Less- pad twice for light soil (2 hours). , LITE will be displayed. Choosing the soil level of the oven automatically programs the self-cleaning time. LOCK flashes in the display. 5. After four seconds, the oven will start cleaning. , The cleaning time will start counting down in the display. , LOCK will appear in the display and will flash until the doors are locked. LOCK will then remain lit. , CLEAN will remain lit in the display. To Delay a Self=Clean Cycle: 1. Press the Delay pad. , DELAY and 00:00 appear in the display. , The colon flashes in the display. 2. Press the More+ or Less= pad to set the amount of time you want to delay the cycle. Delay time can be set from ten minutes (10:00) to 11 hours, 59 minutes (11:59). Cont. * Brand names for cleaning products are registered trademarks of the respective manufacturers. 16