Maytag MFX2876DRE Use & Care Guide - Page 7
Remove Drawer Front, Replace Drawer Front, Reconnect Wiring
View all Maytag MFX2876DRE manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
1. Open the drawer to its full extension, and remove the large interior bin. 2. Locate the wiring cover on the backside of the drawer front. Press tab on the cover to release the snaps, and pull off cover to reveal the wiring connection. 3. Lift the drawer front up and off the drawer glide brackets. A A B C B A. Press tab B. Wiring connection cover 3. On one side of the wiring connector, insert the screwdriver blade between the connector tab and the connector to release. Repeat for the opposite side. Pull the wiring connector apart. A. Loosen top screws B. Drawer glide bracket C. Remove bottom screws 4. Slide the drawer glides back into the refrigerator. Replace Drawer Front 1. Pull out the drawer glides until they are fully extended. 2. Lower the loosened screws in the top of the drawer front into the upper notches in the drawer glides. NOTE: It helps if one person holds the drawer glides steady while another person aligns the drawer front and inserts the screws into the notches. 3. Align the holes in the bottom of the drawer front with the holes in the bottom of the drawer glides and fasten with the screws removed earlier. 4. Tighten the two top screws. Reconnect Wiring 1. Align the two ends of the wiring connector and push them together until you hear a "click" sound and feel the tabs snap into place on the connector. 2. Gently pull on the wiring connection to ensure the wiring connection is completely seated. Replace the wiring cover. NOTE: The wiring connection must be complete for the drawer temperature control to operate. Remove Drawer Front 1. Using a ¹⁄₄" hex head nut driver, remove the two bottom screws (one on each side) attaching the drawer front to the drawer glides. 2. Using ¹⁄₄" hex head nut driver, loosen the two top screws (one on each side) attaching the drawer front to the drawer glides. NOTE: Loosen the screws three to four turns. Keep the screws in the drawer front. 3. Replace the interior bin. 7