Maytag MFX2876DRE Use & Care Guide - Page 8
Location Requirements
View all Maytag MFX2876DRE manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Freezer Drawer Remove Drawer Front 1. Open the freezer drawer to its full extension. 2. Loosen the two top screws that fasten the drawer front to the drawer glides. The two screws (one on the left-hand side and one on the right-hand side) are located inside the drawer front. 3. Lift up on the drawer front to release the plastic studs from the drawer glide bracket slots. A Final Steps WARNING Electrical Shock Hazard Plug into a grounded 3 prong outlet. Do not remove ground prong. Do not use an adapter. Do not use an extension cord. Failure to follow these instructions can result in death, fire, or electrical shock. A. Drawer glide bracket slots 4. Slide the drawer glides back into the freezer. Replace Drawer Front 1. Pull out the freezer drawer glides to their full extension. 2. Holding the drawer front by its sides, align the two plastic studs, located at the bottom, inside the drawer front, with the drawer glide bracket slots. NOTE: It helps if one person holds the drawer glides steady while another person aligns the drawer front and inserts the studs into the slots. A B 1. Plug into a grounded 3 prong outlet. 2. Reset the controls. See "Using the Control(s)" and "Temperature Controlled Exterior Drawer." 3. Return all removable parts and the food to the drawers. Location Requirements WARNING Explosion Hazard Keep flammable materials and vapors, such as gasoline, away from refrigerator. Failure to do so can result in death, explosion, or fire. IMPORTANT: This refrigerator is designed for indoor, household use only. To ensure proper ventilation for your refrigerator, allow for a ¹⁄₂" (1.25 cm) of space on each side and at the top. Allow for a 1" (2.54 cm) space behind the refrigerator. If your refrigerator has an ice maker, allow extra space at the back for the water line connections. When installing your refrigerator next to a fixed wall, leave a 3³⁄₄" (9.5 cm) minimum space between the refrigerator and wall to allow the door to swing open. A. Drawer front screw B. Drawer front plastic stud 3. Replace and tighten the two screws at the top of the drawer front (one on the left-hand side and one on the right-hand side). 8