Maytag MGDC700VW User Instructions - Page 6
Troubleshooting - parts
UPC - 883049145754
View all Maytag MGDC700VW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Moving care - Electric Dryers For power supply cord-connected dryers: 1. Unplug the power supply cord. 2. Make sure leveling legs are secure in dryer base. 3. Use masking tape to secure dryer door. For direct-wired dryers: Electrical Shock Hazard Disconnect power before servicing. Replace all parts and panels before operating. Failure to do so can result in death or electrical shock. Moving care - Gas Dryers 1. Unplug the power supply cord. 2. Close shutoff valve in gas supply line. 3. Disconnect gas supply line pipe and remove fittings attached to dryer pipe. 4. Cap the open fuel supply line. 5. Make sure leveling legs are secure in dryer base. 6. Use masking tape to secure dryer door. ....... t._: g},,, 1o Unplug dryer or disconnect power. 2. Open the dryer door. I_ocate the light bulb cover on the back wall of the dryer. Remove the screw located in the lower righthand corner of the cover. Remove the cover. 1. Disconnect powen 2. Disconnect wiring. 3. Make sure leveling legs are secure in dryer base. 4. Use masking tape to secure dryer door. 3° Turn bulb counterclockwise. Replace the bulb with a lO-watt appliance bulb only. Replace the cover and secure with the screw. 4. Plug in dryer or reconnect power. TROUBLESHOOTING First try the solutions suggested here or visit our website and reference FAQs (Frequently Asked Questions) to possibly avoid the cost of a service call... In U.S.A. http://maytag.custhelp.com - In Canada www.maytag.ca _W:It' Dryer will not run Has a household fuse blown, or has a circuit breaker tripped? Electric dryers use 2 household fuses or circuit breakers. The drum may be turning, but you may not have heat. Replace the fuse or reset the circuit breaker. If the problem continues, ca[[ an electrician. • Is the correct power supply available? Electric dryers require 240-volt power supply. Check with a qualified electrician. • Was a regular fuse used? Use a time-delay fuse. • Is the dryer door firmly closed? • Was the Start button firmly pressed? • Is a cycle selected? The dryer will not start in the Wrinkle Prevent position. Move the dial past OFF. No heat Has a household fuse blown, or has a circuit breaker tripped? Electric dryers use 2 household fuses or circuit breakers. The drum may be turning, but you may not have heat. Replace the fuse or reset the circuit breaker. If the problem continues, ca[[ an electrician. • For gas dryers, is the valve open on the supply line? Unusual sounds • Has the dryer had a period of non-use? If the dryer hasn't been used for a while, there may be a thumping sound during the first few minutes of operation. • Is a coin, button, or paper clip caught between the drum and front or rear of the dryer? Check the front and rear edges of the drum for small objects. Clean out pockets before laundering. • Is it a gas dryer? The gas valve clicking is a normal operating sound. • Are the four legs installed, and is the dryer level front to back and side to side? The dryer may vibrate if not properly installed. See the Installation Instructions. Is the clothing knotted or balled up? When balled up, the load will bounce, causing the dryer to vibrate. Separate the load items and restart the dryer.