Maytag MTF2142EEW User Instructions - Page 11

2. Hand wash, rinse, and dry removable parts and interior surfaces thoroughly. Use a clean sponge or soft cloth and a mild detergent in warm water. 3. Wash stainless steel and painted metal exteriors with a clean sponge or soft cloth and a mild detergent in warm water. 4. There is no need for routine condenser cleaning in normal home operating environments. If the environment is particularly greasy or dusty, or there is significant pet traffic in the home, the condenser should be cleaned every 2 to 3 months to ensure maximum efficiency. If you need to clean the condenser: Remove the base grille. Use a vacuum cleaner with a soft brush to clean the grille, the open areas behind the grille and the front surface area of the condenser. • Replace the base grille when finished. 5, Plug in refrigerator or reconnect power. NOTE: Not all bulbs will fit your refrigerator. Be sure to replace the bulb with an appliance bulb of the same size, shape, and wattage. 1. Unplug refrigerator or disconnect power. 2. Remove the bulb from behind the control panel in the refrigerator or from behind the light shield in the freezer (on some models). Replace it with an appliance bulb of the same wattage. 3. Plug in refrigerator or reconnect power. TROUBLESHOOTING First try the solutions suggested here or visit our website and reference FAQs (Frequently Asked Questions) to possibly avoid the cost of a service call. In the U.S.A., www.maytag.com In Canada, www.maytag.ca The refrigerator will not operate Electrical Shock Hazard Plug into a grounded 3 prong outlet. Do not remove ground prong. Do not use an adapter. Do not use an extension cord, Failure to follow these instructions can result in death, fire, or electrical shock. Power cord unplugged? Plug into a grounded 3 prong outlet. Is outlet working? Plug in a lamp to see if the outlet is working. Household fuse blown or circuit breaker tripped? Replace the fuse or reset the circuit breaker. If the problem continues, call an electrician. Is control on? Make sure the refrigerator control is on. See "Using the Control." New installation? Allow 24 hours following installation for the refrigerator to cool completely. NOTE: Adjusting the temperature control to coldest setting will not cool the refrigerator more quickly. The motor seems to run too much Your new refrigerator may run longer than your old one due to its high-efficiency compressor and fans. The unit may run even longer if the room is warm, a large food load is added, the door is opened often, or if the door has been left open. The refrigerator seems noisy Refrigerator noise has been reduced over the years. Due to this reduction, you may hear intermittent noises from your new refrigerator that you did not notice from your old model. Below are listed some normal sounds with explanations. • Pulsating - fans/compressor adjusting to optimize performance. • Hissing/Rattling - flow of refrigerant, movement of water lines, or from items placed on top of the refrigerator, • Popping - contraction/expansion of inside walls, especially during initial cool-down. • Water running/dripping - may be heard when water melts during defrosting and runs into the drain pan. The door will not close completely • Door blocked open? Move food packages away from door. • Bin or shelf in the way? Push bin or shelf back in the correct position. • Crisper cover in the way? Make sure the crisper cover is fully pushed in, so that the back rests on the supports. 11