Maytag MTW5600TQ Use and Care Guide - Page 11

4. Usingpliersti,ghtetnhecouplingwsithanadditiontawl o-thirdtusrn. 3. Wrapthedrainhosetothelaundrtyublegd, rainstandpipoerinlethosews,iththebeaded NreOsuTlEtD.:onotoverfightoernusetapeorsealanotsnthevalveD. amagtoethevalvecsan tiestrapP. usfhastenienrtothenearehsot leinthebeadetidestrapS.eeviewAorB. 5. Attacthhecoldwatehr osetothetopinletvalve. 6. Screwoncouplinbgyhanduntilitisseateodnthewasher. 7. Usingpliersti,ghtetnhecouplingwsithanadditiontawl o-thirdtusrn. NreOsuTlEtD.:onotoverfightoernusetapeorsealanotsnthevalveD. amagtoethevalvecsan Check for leaks Turn on tile water faucets and check for leaks. A small amount of water might enter the washer. You will drain this later. NOTE: Replace inlet hoses after 5 years of use to reduce the risk of hose failure. Record hose installation or replacement dates for future reference. • If you connect only one water hose, you must cap off the remaining water inlet port. • Periodically inspect and replace hoses if bulges, kinks, cuts, wear, or leaks are found. If the washer faucets and the drain standpipe are recessed, put the formed end of the drain hose into the standpipe. Tightly wrap the tie strap around the water inlet hoses and the drain hose. See view C. Properly leveling your washer avoids excessive noise and vibration. Install the Front Leveling Feet 1. Prop up the front of the washer about 4" (10.2 cm) with a wood block or similar object [he block needs to support the weight of the washer. 9eciure he D "a H }se 1. Remove the shipping material from the power cord. Drape the power cord over the console. 2. Remove any cardboard used to move washer. (Z;> A Beade'd tie strap 4" (10.2 cm) A. Threaded holes for fe'et