McAfee DTP-165C-DPVG Installation Guide - Page 11
Setting up the hardware, Adding devices and servers, Check the shipment
View all McAfee DTP-165C-DPVG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
2 Setting up the hardware This Quick Start serves as a high-level road map for setting up your McAfee DLP system. McAfee DLP Manager is shipped pre-installed; the other products in the suite (McAfee DLP Monitor, McAfee DLP Discover, and McAfee DLP Prevent) must be installed on-site. McAfee DLP Monitor must be set up to capture network traffic, so it requires additional configuration steps. Contents Adding devices and servers Check the shipment Plan your installation Rack mount the appliances Connect a management console Configure McAfee DLP Manager Select an integration mode for McAfee DLP Monitor Complete the setup Adding devices and servers The final setup for McAfee Total Protection for Data Loss Prevention depends on your protection strategy. After you complete setup of all of the appliances, go to the System tab on McAfee DLP Manager to add the products to be managed and the servers needed to complete the system. For example, depending on your objectives, you might add McAfee DLP Discover or McAfee DLP Prevent, which require additional configuration. If you add McAfee DLP Endpoint to the network product suite, you must install it on McAfee® ePolicy Orchestrator®, and add endpoint, evidence, and directory servers. Check the shipment Each product ships with all of the material needed to install it on a network. Check each shipment to verify that all items on the packing list have been received. Task 1 Refer to your Accessory Kit Content List to ensure that you received the following items: • Region-specific power cords - 2 • CAT5 cables - 3 • Serial cable: RJ-45 to RS-232 - Cisco console cable McAfee Data Loss Prevention 9.2.0 Installation Guide 11