NEC 50XC10 42XC10 50XC10 60XC10 user's manual - Page 10

English Installation - continued Mounting on Ceiling • Ensure that the ceiling is sturdy enough to support the weight of the unit and the mounting apparatus over time, against earthquakes, unexpected vibrations, and other external forces. • Be sure the unit is mounted to a solid structure within the ceiling, such as a support beam. Secure the monitor using bolts, spring lock washers, washer and nut. • DO NOT mount to areas that have no supporting internal structure. DO NOT use wood screws or anchor screws for mounting. DO NOT mount the unit to trim or to hanging fixtures. Maintenance • Periodically check for loose screws, gaps, distortions, or other problems that may occur with the mounting apparatus. If a problem is detected, please refer to qualified personnel for service. • Regularly check the mounting location for signs of damage or weakness that may occur over time. Please note the following when mounting on wall or ceiling. • When using mounting accessories other than those that are NEC approved, they must comply with the VESAcompatible (FDMlv1) mounting method. • NEC strongly recommends using size M8 screws (16mm + thickness of bracket in length). If using screws longer than 16mm, check the depth of the hole.(Recommended Fasten Force: 1125 - 1375N•cm) NEC recommends mounting interfaces that comply with UL1678 standard in North America. Unit Mounting Bracket Screw 16mm Thickness of Bracket Screw length should equal depth of hole (16mm) + the thickness of mounting bracket. Cable Management To conveniently manage cables, use the cable clamps provided to bundle the power cord together with the signal and audio cables at the back of the display. To attach cable clamps: 1. Attach the cable clamps to the display. Insert the anchor of the clamp into the hole on the back of the display. There are 4 cable clamps and 4 clamp holes on the unit. 2. After the cable clamp is positioned on the display, wrap the end around the cables. Place the end of the clamp into the slot near the anchor. Pull until cables are snug. Clamps are designed to stay in place. Once in position, they will be difficult to remove. 3. Cables can be routed to the right or left of the clamp. Use the beaded bands to secure the cables together along their length. Make sure the cables are fully supported. To detach clamps: Using pliers, twist the clamp 90 degrees and pull outward. It is possible that the clamp can weaken over time and removing it may cause damage to the clamp. Anchor Slot Holes for Clamp anchors Closed Clamp Orientation DO NOT use this monitor in the portrait position. Doing so may cause failure and void the warranty. English-7