NEC LCD4620-2-IT LCD4020/4620/5220/6520, M40/M46 external control commands - Page 2
Communication Format - its
UPC - 805736021950
View all NEC LCD4620-2-IT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
4. Communication Format Header Message Check Code Delimiter The command packet consists of four parts, Header, Message, Check code and Delimiter. Sequence of a typical procedure to control a monitor is as follows, [A controller and a monitor, two-way communication composition figure] Controller Monitor Get Parameter Delimiter Check Code Message Header Get Parameter Reply Header Message Check Code Delimiter Set Parameter Delimiter Check Code Message Header Set Parameter Reply Header Message Check Code Delimiter Get Parameter Delimiter Check Code Message Header Get Parameter Reply Header Message Check Code Delimiter Save Current Setting Command Delimiter Check Code Message Header The controller sends command to get a value from the monitor that you want to change. The monitor replies a current value of the requested item. The controller sends commands to set an adjusted value. The monitor replies to the controller for confirmation. The controller sends command to get a value for confirmation. The monitor replies an adjusted value. The controller requests to store the adjusted value to the monitor. 4.1 Header block format (fixed length) Header Message Check code Delimiter SOH Reserved Destination Source Message Message '0' Type Length 1st 2nd 3rd 4th 5th 6th -7th 1stbyte) SOH: Start of Header ASCII SOH (01h) 2ndbyte) Reserved: Reserved for future extensions. On this monitor, it must be ASCII '0'(30h). 3rdbyte) Destination: Destination equipment ID. (Receiver) Specify a commands receiver's address. This value must match the "Monitor ID No." set in the OSD. (2/40)