NEC P221W-BK MultiSync P221W-BK : user's manual - Page 11

English Remove Monitor Stand for Mounting To prepare the monitor for alternate mounting purposes: 1. Disconnect all cables. 2. Place hands on each side of the monitor and lift up to the highest position. 3. Place monitor face down on a non-abrasive surface (Figure S.1). Figure S.1 4. Place one hand around the base and one hand on the Quick Release Lever. Move the Quick Release Lever in the direction indicated by the arrows (Figure S.2). 5. Lift up the bottom of the stand to unhook it from the monitor (Figure S.3). The monitor can now be mounted using and alternate method. Reverse process to reattach stand. NOTE: Use only VESA-compatible alternative mounting method (100 mm pitch). NOTE: Handle with care when removing monitor stand. Up Slide Figure S.2 Figure S.3 Flexible Arm Installation This LCD monitor is designed for use with a flexible arm. 1. Follow the instructions on how Remove Monitor Stand for Mounting to remove the stand. 2. Change the 4 screws that were removed from the stand removal to attach the flexible arm to the monitor (Figure F.1). Caution: • When mounting, use ONLY the screws (4 pcs) that were removed from the stand to avoid damage to the monitor 100mm or stand. • The monitor should only be used with an approved arm (e.g. GS mark). • When using mounting accessories (e.g. VESA (100 x 100), use M4 size screws (Length: bracket thickness + 10mm). Recommended Fasten Force: 98 - 137N•cm. • To avoid blocking vent, keep adequate space above and behind the monitor when using with flexible arm. NOTE: The mounting stand must be able to sustain at least 24.4 kg and be UL certified. 100mm Weight of LCD assembly: 6.1 kg MAX Figure F.1 English-9