Netgear CSM4532 Software Administration Manual - Page 179
Enable OSPF on the switch and specify a router ID.
View all Netgear CSM4532 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 179 highlights
3. Configure the VLANs for routing and assign the interface port numbers. (Switch) (Config)#interface vlan 70 Interface vlan 70 created for VLAN ID 70 (Switch) (if-vlan70)#interface vlan 80 Interface vlan 80 created for VLAN ID 80 (Switch) (if-vlan80)#interface vlan 90 Interface vlan 90 created for VLAN ID 90 (Switch) (if-vlan50)#exit 4. Enable routing on the switch. (Switch) #configure (Switch) (Config)#ip routing 5. Assign IP addresses for VLANs 70, 80 and 90. (Switch) (Config)#interface vlan 70 (Switch) (if-vlan70)#ip address 192.150.2.2 255.255.255.0 (Switch) (if-vlan70)#exit (Switch) (Config)#interface vlan 80 (Switch) (if-vlan80)#ip address 192.150.3.1 255.255.255.0 (Switch) (if-vlan80)#exit (Switch) (Config)#interface vlan 90 (Switch) (if-vlan90)#ip address 192.150.4.1 255.255.255.0 (Switch) (if-vlan90)#exit 6. Enable OSPF on the switch and specify a router ID. (Switch) (Config)#router ospf (Switch) (Config-router)#router-id 192.150.9.9 (Switch) (Config-router)#exit 7. Configure the OSPF area ID and cost for each interface. Note: OSPF is globally enabled by default. To make it operational on the router, you configure OSPF for particular interfaces and identify which area the interface is associated with. (Switch) (Config)#interface vlan 70 (Switch) (if-vlan70)#ip ospf area 0.0.0.0 (Switch) (if-vlan70)#ip ospf cost 32 (Switch) (if-vlan70)#exit NETGEAR M4500 Series Switches Software Administration Manual 179