Netgear EX6400 Installation Guide - Page 12
Connect an Ethernet-Enabled Device - range extender setup
View all Netgear EX6400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
20. Test the new extended WiFi range by moving your client device to the area with a poor router WiFi signal: a. Leave your client device in the area with a poor router WiFi signal and return to the extender. b. Check the Client Link LED on the extender: • If the Client Link LED is solid green or amber, your new extender WiFi network reaches the area with a poor router WiFi signal and your network setup is complete. • If the Client Link LED is red, your new extender WiFi network does not reach the area with a poor router WiFi signal. You must move your client device closer to the extender until the Client Link LED turns solid green or amber. Connect an Ethernet-Enabled Device After the extender is connected to your existing WiFi network, you can connect a wired device to the extender using an Ethernet cable. That device can then access your existing network through the WiFi connection. Extender Router Blu-ray player 12