Netgear WG302 WG302v1 Reference Manual - Page 62
Table 4-1., General Information Fields, This screen shows the following parameters
UPC - 606449030365
View all Netgear WG302 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 62 highlights
Reference Manual for the NETGEAR ProSafe Wireless Access Point 802.11g WG302 This screen shows the following parameters: Table 4-1. General Information Fields Field Access Point Information Access Point Name (NetBIOS name) MAC Address Country/Region Firmware Version Access Point Mode Current IP Settings IP Address Subnet Mask Default Gateway DHCP Client Current Wireless Settings Operating Mode Wireless Network Name (SSID) Channel/Frequency WEP/WPA AutoCell Rogue AP Detection Description The default name may be changed if desired. Displays the Media Access Control address (MAC address) of the wireless access point's Ethernet port. Displays the domain or region for which the wireless access point is licensed for use. It may not be legal to operate this wireless access point in a region other than one of those identified in this field. The version of the firmware currently installed. Identifies the operating mode of the WG302: Access Point, Point-to-point bridge, Multi-point bridge or Repeater. The IP address of the wireless access point. The subnet mask for the wireless access point. The default gateway for the wireless access point communication. Enabled indicates that the current IP address was obtained from a DHCP server on your network. Disabled indicated a static IP configuration. Identifies the 802.11 operating mode of the WG302. Displays the wireless network name (SSID) being used by the wireless port of the wireless access point. The default is NETGEAR. Identifies the channel the wireless port is using. 11 is the default channel setting. See "Wireless Channels" on page B-7 for the frequencies used on each channel. WEP/WPA setting. AutoCell setting. Rogue AP detection setting. 4-6 Management July 2005 v3.0