Netgear WG302 WG302v1 Reference Manual - Page 83
Troubleshooting, No lights are lit on the access point.
UPC - 606449030365
View all Netgear WG302 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 83 highlights
Chapter 6 Troubleshooting This chapter provides information about troubleshooting your NETGEAR ProSafe Wireless Access Point 802.11g WG302. After each problem description, instructions are given to help you diagnose and solve the problem. For the common problems listed, go to the section indicated. • Is the WG302 on? • Have I connected the wireless access point correctly? Go to "Installing the WG302 Access Point" on page 3-5. • I cannot remember the wireless access point's configuration password. Go to "Changing the Administrator Password" on page 4-12. Note: For up-to-date WG302 installation details and troubleshooting guidance visit http://kbserver.netgear.com/products/WG302.asp. If you have trouble setting up your WG302, check the tips below. No lights are lit on the access point. It takes a few seconds for the power indicator to light up. Wait a minute and check the power light status on the access point. If the access point has no power. • Make sure the power cord is connected to the access point. • Make sure the power adapter is connected to a functioning power outlet. If it is in a power strip, make sure the power strip is turned on. If it is plugged directly into the wall, verify that it is not a switched outlet. • Make sure you are using the correct NETGEAR power adapter supplied with your access point. Troubleshooting 6-1 July 2005 v3.0