NordicTrack 9600 Treadmill English Manual - Page 8
How To Set Up The Treadmill
View all NordicTrack 9600 Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
HOW TO SET UP THE TREADMILL Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Assembly can be completed using the included allen wrenches. 1. Slide the Right and Left Uprights (95, 97) onto the brackets near the front of the Frame (76). Make sure that the 1 Uprights are on the correct sides; the indicated holes must be facing inward as shown. Raise the Right Upright (95) until the lower hole in the 97 front of the Upright is aligned with the upper hole in the bracket. Thread an Upright Bolt (96) into the Upright and the bracket. Do not fully tighten the Upright Bolt yet. Holes 96 95 96 Repeat this step with the Left Upright (97). 76 2. While a second person holds the Handrail (91) near the Uprights (95, 97), feed the wires in both sides of the Handrail down into the Uprights. Pull the ends of the wires out of the lower ends of the Uprights. If there are wire ties on the ends of the wires, remove them. Finger tighten eight Handrail Bolts (99) into the Uprights (95, 97) and the Handrail (91). Do not tighten the Handrail Bolts yet. Be careful to avoid pinching the wires. Note: The CD Holder (86) and the Cup Holder (85) are replaceable. If these parts become dislodged from the Console Base (89), simply press them back into place. 2 86 99 91 99 97 Wires 89 85 99 95 3. Connect the TV Cable (17) and the Right Power Wire Harness (57) in the indicated locations. The connectors 3 95 should slide together easily and snap into place. If 97 they do not, turn the connector on the Right Power Wire Harness and try again. IF THE CONNECTORS ARE NOT CONNECTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON. Push all of the excess wire up into the Uprights (95, 97). Make sure that all wires are fully connected. Note: Regardless of which console your treadmill has, con- nect all wires so that the console can later be up- graded if desired. 17 57 7