NordicTrack C 1500 Pro Treadmill English Manual - Page 7

ASSEMBLY • Assembly requires two persons. • Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until you finish all assembly steps. • The underside of the walking belt is coated with high-performance lubricant. After shipping, there may be some lubricant on top of the walking belt or on the shipping carton. This is normal. If there is lubricant on top of the walking belt, wipe it off with a soft cloth and a mild, non-abrasive cleaner. • To identify small parts, see page 6. • A ssembly requires the following tools: the included hex key one adjustable wrench one Phillips screwdriver To avoid damaging parts, do not use power tools. 1. Make sure that the power cord is unplugged. 1 Attach the Left Wheel Cap (96) to the Base (94) with two #8 x 3/4" Screws (2).  Attach the Right Wheel Cap (not shown) to the Base (94) in the same way. 94 2 96 2. Pull the Upright Wire (81) and the base ground wire (A) through the indicated hole in the Base (94) using the plastic tie. Attach the base ground wire (A) to the Base (94) with a #8 x 1/2" Ground Screw (10).  Press the Grommet (77) into the square hole in the Base (94).  See the inset drawing. Cut the plastic tie near the Upright Wire (81). Be careful not to damage the Upright Wire. 2 Tie Square Hole 77 Hole 81 10 Tie Cut 81 A 94 7