NordicTrack Gx 7.0 Pro Bike English Manual - Page 25

HOW TO ADJUST THE DRIVE BELT If the pedals slip while you are pedaling, even while the resistance is adjusted to the highest setting, the drive belt may need to be adjusted. Loosen the M6 x 20mm Hex Screw (84). Tighten the M10 x 50mm Hex Screw (83) until the Drive Belt (47) is tight. When the Drive Belt is tight, tighten the M6 x 20mm Hex Screw. To adjust the drive belt, first unplug the power adapter (not shown). 47 See EXPLODED DRAWING B on page 31. Using an adjustable wrench, turn the Left Pedal (22) clockwise and remove it. See EXPLODED DRAWING A on page 30. Using a flat screwdriver, gently release the tabs on the Front Shield (58) and the Top Shield (44). Remove the Front Shield and slide the Top Shield upward. 84 83 Remove all the Screws (77, 85) from the Left and Right Front Shields (13, 14); make sure to note the location of each size of Screw. Using a flat screwdriver, gently release the tabs on the left Shield Disc (52). Rotate the Shield Disc and remove it. Then, gently remove the Left Front Shield (13). When the drive belt is correctly adjusted, reattach the left and right shields, the top shield, the front shield, the left pedal disc, and the left pedal. Then, plug in the power adapter. 25