NordicTrack Ntevel19016 Instruction Manual - Page 9

8. Route the right Strap (119) under the right Roller (67); make sure that the Strap is not twisted 8 and that it is routed under the Roller. Attach the right Strap (119) to the right rear Glide Belt Cover (63) with three M6 x 16mm Screws (111) and a Strap Clamp (64); start all the Screws, and then tighten them. Repeat this step on the other side of the elliptical. 67 63 119 64 111 9. Tip: Avoid pinching the wires. Insert the Console Bracket (3) into the Upright (2). Attach 9 the Console Bracket with two M8 x 68mm Screws (125). Then, connect the wires from the Console (4) to the Main Wire (141), the Right and Left Control Wires (12, 13), and the Accelerometer Wire (138). 125 3 12 2 4 Avoid pinching the wires 141 13 138 125 10. Tip: Avoid pinching the wires. Attach the Upper Neck Cover (17) to the Upper Bridge Cover (16) with an M4 x 16mm Screw (98). 10 98 17 16 Avoid pinching the wires 11. Make sure that all parts are properly tightened before you use the elliptical. Extra parts may be included. Place a mat beneath the elliptical to protect the floor. 9