NordicTrack Ntevex76017 Instruction Manual - Page 6

ASSEMBLY • Assembly requires two persons. • Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until you finish all assembly steps. • Left parts are marked "L" or "Left" and right parts are marked "R" or "Right." • To identify small parts, see page 5. In addition to the included tool(s), assembly requires the following tools: one Phillips screwdriver one adjustable wrench Assembly may be easier if you have a set of wrenches. To avoid damaging parts, do not use power tools. 1. To register your product and activate your warranty in the UK, go to iconsupport.eu. If 1 you do not have internet access, call Customer Service (see the front cover of this manual).  To register your product and activate your warranty in Australia, email or post the following information to the email address or postal address on the front cover of this manual. • your receipt (make sure to keep a copy) • your name, address, and telephone number • the model number, serial number, and name of your product (see the front cover of this manual) 2. If there are shipping bracket(s) on the front and rear of the Frame (1), remove and discard the 2 shipping bracket(s) and the hardware attaching them. With the help of a second person, place some of the packing materials (not shown) under the front of the Frame (1). Attach the Front Stabilizer (2) to the Frame (1) with two M10 x 96mm Screws (110); start both Screws, and then tighten them. Then, remove the packing material from under the Frame (1). 2 110 1 6