Oki GL408e GL408e/GL412e User's Guide - Page 48

Unit 4: Printer Configuration WIRELESS LOCAL AREA NETWORK (WLAN) INTERFACE MODE This chapter provides the programming sequences required for WLAN interface setup. Use the keys of the printer's operator panel to select and enter the required options. Refer to the Menu Definition Tables in the following chapter to provide an explanation of each menu screen. ATTENTION: Perform the following programming sequence only if this is the interface type to be used. Instead, refer to the appropriate interface programming chart. Screens only display if Admin User is enabled within the Advanced Mode POWER A ONLINE LINE OFFLINE ENTER INTERFACES Interface Mode ENTER INTERFACES Ignore CR/LF Item No. Check BCC Check History Buffer Comm. Protocol Host Interface ETHERNET PORT ETHERNET SETTING WLAN ADDRESS WLAN SETTING Parallel Port USB Port Serial Port Printer Mgt Ignore CR/LF No* Item No. Check Disable* BCC Check Disable* History Buffer Temporary* Comm. Protocol Status 5* A INTERFACES Host Interface* Host Interface Auto Switching* INTERFACES Host Interface* Host Interface Ethernet* A B C D E C C INTERFACES ETHERNET SETTING ETHERNET SETTING NetBIOS Protocol NetBIOS Protocol Enable* ASCII Data Port 1024* Keep Alive Timer 3 minutes* Ethernet Speed Auto Select* Job Control Standard* Offline Process Disable* B INTERFACES ETHERNET PORT ETHERNET PORT Timeout Timeout 10 sec* Switch Out On Data Timeout* D WLAN ADDRESS IP Address Subnet Mask Gateway Address MAC Address DHCP IP Address XXX.XXX.XXX.XXX Subnet Mask XXX.XXX.XXX.XXX Gateway Address XXX.XXX.XXX.XXX MAC Address XXX.XXX.XXX.XXX DHCP Disable* Figure 4-9, WLAN Interface Mode GL408-412e Operator Manual 4-12 PN: 9001163A