Onkyo A-9555 Owner Manual - Page 17
Using the MAIN IN Function A-9755, Recording - amp
View all Onkyo A-9555 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Enjoying Audio Sources-Continued Using the MAIN IN Function (A-9755 only) You can use the A-9755 as power amplifier with a separate preamp. See page 13 for connection information. Recording Unless you have the full consent of the copyright holder, copyright laws prohibit using your recordings for anything other than personal enjoyment! POWER AMP DIRECT (MAIN IN) 1 Press the [POWER AMP DIRECT (MAIN IN)] button for 3 seconds until the MAIN IN indicator lights up. The MAIN IN function comes on and the MAIN IN indicator lights up. While the MAIN IN function is on, only audio from components connected to the preamp can be output. To turn the MAIN IN function off, press the [POWER AMP DIRECT (MAIN IN)] button for 3 seconds until the MAIN IN indicator goes off. Notes: • Do not connect a component that does not have an output volume control to the MAIN IN jacks and use the MAIN IN function, because the sound will be output at maximum volume and may damage the A-9755 and your speakers. • While the MAIN IN function is on, the A-9755's Volume control has no effect. Before you turn off the MAIN IN function, make sure that the Volume control is not turned up high, to prevent any loud surprises. • While the MAIN IN function is on, the following A-9755 functions are disabled: - Volume control - Input selector - Remote control operation - function - LOUDNESS control - Recording - Muting Operate the connected preamp for some of these functions including controlling volume, selecting input, and muting. The [STANDBY] and [ON] buttons on the remote controller will work even when the MAIN IN function is on. Input selector 1 Use the input selector to select the component that you want to record from. 2 Prepare the recorder: • Set the recorder so that it's ready for recording. • If necessary, adjust the recording level on the recorder. • See the recorder's manual for more information. 3 Start playback on the component selected in step 1. Note: If you select another input source dur- ing recording, the newly selected input source will be recorded. Notes: • You can record on a recorder that's connected to the MD OUT or TAPE OUT L/R jacks. • The tone controls have no effect on the signal being recorded. • When using the A-9755 as a power amplifier (MAIN IN function), recording is not possible. 17