Onkyo A-9555 Owner Manual - Page 7

Front & Rear Panels-Continued Rear Panel 12 34 5 6 7 8 90AB C (A-9755 only) A Grounding terminal This terminal is for connecting a turntable's ground wire. B PHONO (MM) input This analog audio input is for connecting a turntable with a moving-magnet cartridge. C SPEAKERS A These terminal posts are for connecting speaker set A. D SPEAKERS B These terminal posts are for connecting speaker set B. E AC INLET This connector is for connecting the supplied power cord (see page 5). F CD input This analog audio input is for connecting a CD player's analog audio output. G TUNER input This analog audio input is for connecting a tuner's analog audio output. H TAPE IN/OUT This analog audio input and output are for connecting a cassette deck with an analog audio input and output. I MD IN/OUT This analog audio input and output are for connecting an MD recorder with an analog audio input and output. J HDD IN This analog audio input is for connecting a component's analog audio output (RI Dock, etc.). This illustration is for A-9755. K LINE input This analog audio input is for connecting a component's analog audio output (TV, etc.). L MAIN IN (A-9755 only) This analog audio input is for connecting a separate preamp when you want to use the A-9755 as a power amplifier. Caution: Do not connect a component that does not have an output volume control, such as a CD player, because the sound will be output at maximum volume and may damage the A-9755 and your speakers. M REMOTE CONTROL jacks These (Remote Interactive) jacks can be con- nected to the jacks on your other Onkyo audio components. The A-9755/A-9555's remote controller can then be used to control all of your compo- nents. To use , you must make an analog audio connection between the A-9755/A-9555 and each component. See pages 10-13 for connection information. 7