Onkyo HT-S3800 Quick Start Guide - Page 15
Troubleshooting, Resetting the Main Unit, VENTILATION CAUTION
View all Onkyo HT-S3800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
SN29402473_HT-S3800_QSG_EnFrEs.book 15 Press (e) several times to check various settings in the following order: listening mode # volume # input audio format # input source. Important: The listening modes may not be available depending on the current source, settings and status of the receiver. You can also see which audio format is being input by checking the indicators in the lower part of the display. This unit is compatible with the following digital audio formats. (with HDMI connection) 0 Dolby Digital 0 Dolby Digital Plus 0 Dolby TrueHD 0 DTS 0 DTS 96/24 0 DTS Express 0 DTS-HD MasterAudio 0 PCM (32 kHz to 192 kHz sampling frequencies) 0 SACD (DSD 2ch only) 0 DVD Audio (including 192 kHz) Troubleshooting 0 When a sound can not be heard from center and rear speakers, press SURR or DSP to change listening modes. E.g.) Press DSP for several times to select All Ch Stereo. 0 In order to listen to the audio from the source component that is connected to this receiver, press AUDIO SEL to select H (HDMI cable), C1 (coaxial cable), O1 (optical cable), or A (analog audio cable). 0 If there is no sound from the subwoofer: When the front speaker is set to LARGE then, in some cases, no sound may come from the subwoofer. Change the front speaker setting to SMALL or change the subwoofer to PLUS and the sound should be restored. 0 If the power suddenly turns off: - Check that there are no loose strands of speaker wire touching the rear panel or another set of wires. If so, re-attach the speaker wires, making sure there are no stray strands. - When Auto Power Down is set, the power automatically turns off at the set time. 0 We will not accept responsibility for any damage arising from the connection of equipment manufactured by other companies. Resetting the Main Unit Use this procedure to reset all the receiver's settings to the factory default. Use the front panel controls to do this. 1. Switch the receiver into standby. 2. While holding down STEREO, press and hold Í ON/STANDBY for about two seconds. 3. When you see RESET? appear in the display, press SURROUND. OK? shows in the display. En 4. Press DSP to confirm. VENTILATION CAUTION When installing this unit, make sure to leave space around the unit for ventilation to improve heat radiation (at least 40 cm at top, 20 cm at rear, and 20 cm at each side). 15