Onkyo TX-NR676 Owners Manual - Basic/Advanced - Page 48

>>Specifications >>Advanced Setup >>Listening Modes >>Network Functions >>Basic Manual Troubleshooting | Supplementary Information, etc. 3. Audio Adjust Make advanced settings such as those related to multiplex audio, settings for the LFE level, or those related to the volume of this unit. ˙ 1. Multiplex/Mono Setting Item Multiplex Input Channel Mono Input Channel Default Value Main Left + Right Setting Details Set the audio channel or language to be output when playing multiplex audio or multilingual TV broadcasts etc. "Main": Main channel only "Sub": Sub channel only "Main/Sub": Main and sub channels will be output at the same time. • If multiplex audio is being played, "1＋1" will be displayed when on the remote controller is pressed. Set the input channel to use for playing any 2 ch digital source such as Dolby Digital, or 2 ch analog/ PCM source in the Mono listening mode. "Left": Left channel only "Right": Right channel only "Left + Right" : Left and right channels ˙ 2. Dolby Setting Item Loudness Management Default Value On Setting Details When playing Dolby TrueHD, enable the dialog normalization function which keeps the volume of dialog at a certain level. Note that when this setting is Off, the Late Night function that allows you to enjoy surround at low volumes is fixed to off when playing Dolby Digital Plus/Dolby TrueHD. "On": When this function is to be used "Off": When this function is not to be used ˙ 3. DTS Setting Item DTS Auto Surround Default Value On Setting Details When inputting DTS signals that include extended channel information, the optimum listening mode is automatically selected according to the extended information contained in the input signal and the speaker configuration of this unit when playing in the straight decoding listening mode. "On": Use this function "Off": Audio is played using the same amount of channels in the input signal according to the speaker configuration of this unit. • The ES Matrix and ES Discrete listening modes cannot be selected if this function is set to "Off". ˙ 4. LFE Level Set the low-frequency effect (LFE) level for Dolby Digital series, DTS series, Multichannel PCM, and DSD signals. Setting Item LFE Level Default Value 0dB Setting Details Select the low-frequency effect (LFE) level of each type of signal from "0dB" to "ʵ㱣dB". If the lowfrequency effect sound is too strong, select "ʵ20dB" or "ʵ㱣dB". ˙ 5. Volume Setting Item Mute Level Default Value ʵ㱣dB Maximum Volume Off Setting Details Set the volume lowered from the listening volume when muting is on. Select a value from "ʵ㱣dB", "ʵ40dB", and "ʵ20dB". Set the maximum value to avoid too high volume. Select a value from "Off", "50" to "99". 16