Onkyo TX-RZ3100 AV Receiver Basic/Advanced Manual English - Page 47
If Height 1 Speaker is set to Top Front or Dolby
View all Onkyo TX-RZ3100 AV Receiver manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 47 highlights
>>Specifications >>Settings >>Listening Modes >>Playback Function >>Basic Manual Troubleshooting | Appendix Setting Item Default Value Height 2 Speaker Top Rear Zone Speaker No Setting Details Set the speaker type if height speakers are connected to the HEIGHT 2 terminals. Select "Front High", "Top Front", "Top Middle", "Top Rear", "Rear High", "Dolby Speaker (Front)", "Dolby Speaker (Surr)", or "Dolby Speaker (Back)" according to the type and layout of the connected speakers. However, the options selectable for the "Height 1 Speaker" the are as follows. If "Height 1 Speaker" is set to "Front High": Select from "Top Middle", "Top Rear", "Rear High", "Dolby Speaker (Surr)", or "Dolby Speaker (Back)". If "Height 1 Speaker" is set to "Top Front" or "Dolby Speaker (Front)": Select from "Top Rear", "Rear High", "Dolby Speaker (Surr)", or "Dolby Speaker (Back)". If "Height 1 Speaker" is set to "Top Middle": Fixed to "Rear High". • "Dolby Speaker (Surr)" and "Dolby Speaker (Back)" can only be selected when surround speakers or surround back speakers are being used, respectively. You can check speakers that you are using on the figure displayed in "Speaker Channels". • If an item cannot be selected even though connection is correct, check that the settings in "Speaker Channels" matches the number of connected channels. Set the connection of speakers to Zone 2 or Zone 3 speaker terminals. "Zone 2": When speakers are connected only to Zone 2 speaker terminals "Zone 2/Zone 3": When speakers are connected to both Zone 2 and Zone 3 speaker terminals • "Zone 2/Zone 3" cannot be selected when surround back speakers and height speakers are being used. "No": When speakers are not connected to either speaker terminals • This item will be set to "No" when two sets of height speakers are being used. Setting Item Bi-Amp Default Value No Setting Details Set whether the front speakers are bi-amp connected. "No": When front speakers are not bi-amp connected "Yes": When front speakers are bi-amp connected • In any of the following cases, this item will be set to "No": - When two sets of height speakers are being used - When "Zone Speaker" is set to "Zone 2/Zone 3" - When height speakers and ZONE speakers are being used at the same time. 11