Onkyo TX-RZ820 Owners Manual - English - Page 31

> Before Start > Part Names > Install > Initial Setup > Playback Multi-zone 1 2 3 turn the TONE dial to adjust. a b Basic Operations Pure Audio, it will automatically switch to input to be played in the separate room. You can enjoy audio in the separate room the Direct listening mode. 0 On the main unit, after pressing ZONE 2 or ZONE 3, within 8 seconds press by, for example, playing a Blu-ray Disc Perform the following procedure when the the input selector button to select the player in the main room (where this unit is located) and listening to internet radio in unit is on. 1. To switch to the remote controller mode input to be played in the separate room. To play the same source in the c the separate room (ZONE 2/ZONE 3). for controlling ZONE 2, while holding main room and separate room, press d 0 DSD and Dolby TrueHD audio signals down MODE (f) on the remote controller, ZONE 2 or ZONE 3 on the main unit are not output to ZONE 2/ZONE 3 when press ZONE 2 (d) for 3 or more seconds twice. selected with the "NET" input selector. until the remote indicator blinks twice. 4. To adjust the volume on the power 0 You can only select the same inputs for To switch to the remote controller mode amplifier in the separate room or the the main room and separate room with for controlling ZONE 3, while holding ZONE SPEAKER, adjust with volume the "NET" or "BLUETOOTH" input down MODE (f) on the remote controller, buttons on the remote controller. To selector. If you have "NET" selected in press ZONE 3 (e) for 3 or more seconds control on the main unit, press ZONE 2 the main room and then select until the remote indicator blinks three or ZONE 3 and adjust with the MASTER "BLUETOOTH" in the separate room, times. VOLUME within 8 seconds. the main room also switches to 2. Point the remote controller at the main 0 Adjust the volume on the pre-main "BLUETOOTH". You cannot select unit and press Í (a). amplifier if you have connected with a different stations for the main room and "Z2" or "Z3" lights on the main unit pre-main amplifier in the other room. separate room with the AM/FM radio. display. 0 You can also adjust the sound quality 0 Power consumption in standby mode of a power amplifier connected in a increases when the multi-zone function separate room. After pressing either is being used. ZONE 2 or ZONE 3 on the main unit, 0 If ZONE 2 or ZONE 3 is turned on when within 8 seconds press TONE and the listening mode of the main room is 3. Press the input selector button (b) of the F f En 31