Optoma UHZ35ST Manual - Page 50
Control reset menu, RS232 by Telnet Function, Quick Start-Guide for RS232 by Telnet, Search
View all Optoma UHZ35ST manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 50 highlights
USING THE PROJECTOR RS232 by Telnet Function RS232 by Telnet Function As an alternative method of control, this projector has RS232 command control by TELNET for LAN / RJ45 interface. Quick Start-Guide for "RS232 by Telnet" Check and get the IP address on OSD of the projector. Make sure that the PC / laptop can access the web-page of the projector. Make sure that "Windows Firewall" setting is set to disabled in case of "TELNET" function filtering out by PC / laptop. 1. Click on Search and then enter "cmd" as a search word. Press the "Enter" key. 2. Open the Command Prompt app. 3. Input the command format as follows: ± telnet ttt.xxx.yyy.zzz 23 ("Enter" key pressed) ± (ttt.xxx.yyy.zzz: IP-Address of the projector) 4. If Telnet-Connection ready, and user can have RS232 command input, then press the "Enter" key and Telnet connection should be ready for RS232 command control. Specification for "RS232 by TELNET": 1. Telnet: TCP. 2. Telnet port: 23 (for further details, please contact the Optoma service team). 3. Telnet utility: Windows "TELNET.exe" (console mode). 4. To end the Telnet session, just close the Command Prompt app window. 5. Windows Telnet utility directly after TELNET connection ready. ± Limitation 1 for Telnet-Control: There cannot be more than 50 bytes for successive network payload for Telnet-Control application. ± Limitation 2 for Telnet-Control: There cannot be more than 26 bytes for successive RS232 command for Telnet-Control. ± Limitation 3 for Telnet-Control: Minimum delay for next command must be more than 200 (ms). Control reset menu Return the factory default settings for control settings. 50 English