Oreck Air 6 Owners Guide

Oreck Air 6 Manual

Get Oreck Air 6 PDF manuals and user guides View all Oreck Air 6 manuals
Add to My Manuals
Save this manual to your list of manuals

Oreck Air 6 manual content summary:

  • Oreck Air 6 | Owners Guide - Page 1
    S I M P LY A M A Z I N G® Service Manual REV I., Please disregard all earlier versions. Table Top Air Cleaner Super Air 5 / Air 6 Model 447628 & 4478801
  • Oreck Air 6 | Owners Guide - Page 2
    1. Read all instructions. 2. Do not fan. Always disconnect the unit from power prior to cleaning or servicing. General Knowledge Warning - The intent of this manual is to provide general guidance to be used by a qualified service technician in servicing the Oreck tabletop electrostatic air cleaner
  • Oreck Air 6 | Owners Guide - Page 3
    page 4 Trouble Shooting Guide page 5 Parts Removal and Replacement Procedures page 15 Cross Section and Parts List page few, are microscopic in size. Polluted air enters the unit through the front of the air cleaner. The fan pulls in dirty air and the pre-filter traps large particles (hair, lint,
  • Oreck Air 6 | Owners Guide - Page 4
    filters. 2. Wipe down inside of unit with damp cloth. 3. Thoroughly Clean Collecting Cell with Oreck Assail-A-Cell Cleaner blower wheel rotates freely. 10. Check to ensure rubber grommet on motor shaft is not worn or loose. Replace if filter. 13. Install New Post Filter (Activated Charcoal Filter). 4
  • Oreck Air 6 | Owners Guide - Page 5
    Troubleshooting Guide Warning: The troubleshooting portion of this manual requires that the unit power be "ON" for much of the servicing portion of troubleshooting operate on the "fan" selection mode. Problem Being Checked: 1. the problem is that the interlock tight fit so activator post can engage the
  • Oreck Air 6 | Owners Guide - Page 6
    Troubleshooting Guide How to Remove the Power Supply Cover 1. Insert flathead screwdriver into slot on the interior edge of the power supply cover, and push plastic clip
  • Oreck Air 6 | Owners Guide - Page 7
    Troubleshooting Guide 6. Check the voltage to and from the switch when activated. You should be able to measure line voltage entering and leaving the switch when activated cleaning air" light does not operate: a. Remove the cell and check to see if the "cleaning air" light comes on. CLEANING AIR
  • Oreck Air 6 | Owners Guide - Page 8
    Troubleshooting Guide c. If the light does not operate with the cell removed, check the wires to the light and confirm that they are properly connected. Check the
  • Oreck Air 6 | Owners Guide - Page 9
    Troubleshooting Guide e. Check the input voltage to the transformer using a standard lead and a multimeter. Check the voltage from the black lead on the terminal L speed control switch and white lead on power supply board labeled line neutral. Activate If the green "cleaning air" light operates and
  • Oreck Air 6 | Owners Guide - Page 10
    Troubleshooting Guide d. If there are no signs of distortion, remove the blower wheel (see: Blower Wheel Removal) and activate the unit. Notice if the motor shaft rotates without the blower wheel. If the motor shaft operates, the problem is related to the blower wheel. If the motor shaft rotates
  • Oreck Air 6 | Owners Guide - Page 11
    Troubleshooting Guide c. Check to see if the blower wheel is adequately supported by the outside bearing plate assembly. The outboard end of the blower wheel should be firmly supported, allowing no movement other than rotation. If that end of the wheel can be moved front to back and up and down,
  • Oreck Air 6 | Owners Guide - Page 12
    Troubleshooting Guide 6 If the cell is arcing, check the following: a. If there are water. Dry completely before re-installing. c. If there are bent cell plates. Replace the cell by following instructions on inside of cabinet top. d. If the cell is improperly installed in the unit. Reinstall the cell
  • Oreck Air 6 | Owners Guide - Page 13
    Troubleshooting Guide f. If the H.V. contacts are not properly aligned or the contact wall is not properly aligned. The H.V. contacts must make good contact. Replace the contact wall
  • Oreck Air 6 | Owners Guide - Page 14
    Notes 14
  • Oreck Air 6 | Owners Guide - Page 15
    Super Air 5 Model 447628 Parts Removal and Replacement General Parts Replacement Motor Removal and Replacement page page 23 Ionizer Needle Removal and Replacement page 23 Fan Blade Removal and Replacement page 24 Warning - All parts removal and replacement should be performed with power disconnected
  • Oreck Air 6 | Owners Guide - Page 16
    General Parts Replacement Motor Removal and Replacement 1. Remove the cabinet top by pressing down the thumb latch and sliding the top forward. 2. Remove the cell assembly (see inside of top for instructions). 3. Remove the stripper by pulling it to the right and applying pressure to the bearing
  • Oreck Air 6 | Owners Guide - Page 17
    Parts Replacement ROTATING ELEMENT WARNING - Unit has a rotating blower wheel and cooling fan to circulate air and keep the unit cool. When servicing of the wheel at the center support rib and the rib closest to the motor shaft. The blower wheel rubber grommet is glued to the shaft of the
  • Oreck Air 6 | Owners Guide - Page 18
    General Parts Replacement HIGH VOLTAGE WARNING - This equipment is supplied with line voltage from a standard wall socket. Use standard precautions in working on it with line voltage
  • Oreck Air 6 | Owners Guide - Page 19
    and must be in position to properly isolate wiring and connectors from uninsulated parts. Failure to place the boards in the proper location can create a fire You will note that all wiring is bound and well away from the motor fan. The HV power single red line coming from the left hand side of
  • Oreck Air 6 | Owners Guide - Page 20
    and during installation of the power supply cover. ROTATING ELEMENT WARNING - Unit has a rotating blower wheel and cooling fan to circulate air and keep the unit cool. When servicing the unit and repairing the unit always insure that you keep objects and internal electrical wiring away from the
  • Oreck Air 6 | Owners Guide - Page 21
    General Parts Replacement 5. To test the power supply, touch the metal shaft of a screwdriver, . ROTATING ELEMENT WARNING - Unit has a rotating blower wheel and cooling fan to circulate air and keep the unit cool. When servicing the unit and repairing the unit always insure that you keep objects and
  • Oreck Air 6 | Owners Guide - Page 22
    General Parts Replacement 3. Remove the two #8/32 lockwasher nuts and remove the transformer and and wipe it with a clean cloth. 3. You are now ready to reinstall the new lower wheel and grommet assembly. Place one drop of adhesive (loctite 401 or equivalent "super glue" type adhesive) on the motor
  • Oreck Air 6 | Owners Guide - Page 23
    General Parts Replacement Led Assembly Removal and Replacement 1. Follow steps 1, 2, and 6 of Motor Removal and Replacement. 2. Disconnect the two red led leads from the power supply board
  • Oreck Air 6 | Owners Guide - Page 24
    General Parts Replacement EXTREME HIGH VOLTAGE WIRING WARNING - The unit has been Replacement. ROTATING ELEMENT WARNING - Unit has a rotating blower wheel and cooling fan to circulate air and keep the unit cool. When servicing the unit and repairing the unit always insure that you keep objects and
  • Oreck Air 6 | Owners Guide - Page 25
    3 1 1 PART NO. 242235-001 FAN BLADE CHARCOAL COMBINATION FILTER GROMMET HV POWER SUPPLY BOARD HV POWER SUPPLY BOARD "HUMP BACK" CABINET BOTTOM MOTOR ISOLATOR PAD SWITCH ASSEMBLY SWITCH ROCKER CARTON CARTON INSERT CHARCOAL FILTERS (NO LONGER AVAILABLE) CHARCOAL FILTERS CELL CLEANER OWNER'S MANUAL
  • Oreck Air 6 | Owners Guide - Page 26
    RED RED YEL YEL 12 LED BLUE (242477-035) ION./COLL. CELL CONTACT WALL RED (142475-001) GRN GRN GRN RED GRN (242477-027) ©2004 Oreck Holdings, LLC. All rights reserved. All trademarks are owned and used under the authority of
  • Oreck Air 6 | Owners Guide - Page 27
    Notes 27
  • Oreck Air 6 | Owners Guide - Page 28
    ©2004 Oreck Holdings, LLC. All rights reserved. All trademarks are owned and used under the authority of Oreck Holdings, LLC. 75422-01 REV I 08/04 R-7693, R-7695
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
SIMPLY
AMAZING
®
Service Manual
Table Top Air Cleaner
Super Air 5 / Air 6
Model 447628 & 4478801
REV I., Please disregard all earlier versions.