Oreck ProShield Owners Guide - Page 15

Troubleshooting Service problems that appear to be major can often be solved easily. You can be your own troubleshooter by reviewing this guide. All other servicing should be done by an Oreck authorized service center. Problem Unit does not turn ON Truman Cell light has turned solid red. Truman Cell light is blinking red Unit does not remove pollutants. Unit sparks, crackles and pops. Check Solution • Power Cord • Plug in Power Cord • Selector Switch • Set Selector Switch for desired blower speed. • Top Cover • Make sure the top cover is securely closed • ALCI Plug • Press the red reset button each time you plug in the ALCI safety device. Truman Cell • A solid red light is a 30 day cleaning reminder. Wash Collector Cell. Make sure it is thoroughly clean and dry before reinstalling. Truman Cell Truman Cell Truman Cell • A fast blinking light indicates the power supply has shut down due to arcing or short circuit. The cell should be inspected and cleaned, repaired, or replaced. • A slow blinking light indicates the unit is in Dry Mode. • Clean the Truman Cell and make sure it is completely dry before reinstalling. • Truman cell may be damaged. Contact Oreck for service. • Sparking or popping noise (arcing) can occur when a large particle is captured in the Truman Cell. If the unit is arcing excessively, the cell may be dirty. Try cleaning the Truman Cell. • If excessive arcing continues after proper cleaning, the Truman Cell may be damaged or wet. If damaged, contact Oreck for service. 12