Oreck XL2800H2 Owners Guide - Page 8

Troubleshooting Guide WARNING: Unplug cord from electrical outlet before servicing. SAVE SERVICE CALLS...CHECK THESE FIRST: • Is the disposable filter dust bag full? • Are pores of filter dust bag clogged with powder or fine dust? • Is anything clogging the revolving brush, lower tube, intake opening, fan housing or connector assembly opening? • Is the belt in place and turning the brush? • Are the brush ends in the proper location? • Does the brush turn freely? Are hair, string or rug fibers wound around the brush? PROBLEM POSSIBLE SOURCE AREAS TO CHECK CLEANER WILL NOT RUN Not plugged in properly. Be sure cleaner is firmly plugged into wall outlet. No electricity in wall outlet. Check electrical source-fuse or circuit breaker. Plug not firmly in Plug firmly in handle assembly. handle assembly. CLEANER Filter bag is full. DOES NOT PICK UP Replace filter bag. See "To Install Paper Filter Dust Bag." Nozzle or intake Clear obstruction. pivot clogged. Belt is broken or Replace belt. stretched. Brush is worn. Replace brush if bristles do not extend beyond base plate. Bag tube clogged. Clear obstruction. Bag pores are Change bag. clogged with fine dust. Impeller fan is broken. Return to Service Center for repair. Revolving brush is not even at both ends. Check bearing seal. Make sure words "old" or "new" match at each end. ALL OTHER SERVICING SHOULD BE DONE BY AN ORECK AUTHORIZED SERVICE CENTER. CALL CUSTOMER SERVICE HOT LINE US: 1-800-989-3535 CANADA: 1-888-676-7325 Whenever calling, please be sure to have your model and serial number from data plate. ©2002 Oreck Holdings, LLC. All rights reserved. All word marks, logos, product configurations, and registered trademarks are owned and used under the authorization of Oreck Holdings, LLC. 75268-05 REV D 8 12/02 ECN# R-6815