Panasonic AKHC1800N AKHC1800N User Guide - Page 20

How to set up the system When the camera is to be controlled from the AW-RP555 controller Each time the GAIN button is pressed, the setting is switched in the sequence of LOW  MID  HIGH  S.GAIN1, and the mode is displayed by the LEDs as shown below. GAIN button MANU L LED MANU H LED LOW OFF OFF OFF MID OFF ON OFF HIGH OFF OFF ON S.GAIN1 ON OFF OFF When these buttons are pressed while their LEDs are off, the PRESET, USER1 and USER2 files are opened respectively. When a button is pressed while its LED is lit, the CURRENT file is opened. The LED of a button blinks while its file is being opened. For executing AWB.*1 Each time the MODE button is pressed, the setting is switched between CAM and BAR. The MODE button lights up at the BAR setting. For executing ABB.*1 Use these buttons to perform the camera menu operations. MENU: T his operates in the same way as MENU on the camera. ITEM: This operates in the same way as ENTER on the camera. Shutter mode selection Each time this button is pressed, one of the shutter modes set by the controller or "shutter OFF" is selected. The SHUTTER button lights up in all modes except shutter OFF. YES: This operates in the same way as UP on the camera. NO: This operates in the same way as DOWN on the camera. The shutter mode settings established by the PRESET buttons are as follows. MODE 1/100 PRESET No. PRESET1 MODE 1/2000 PRESET No. PRESET6 In the case of the AK-HC1800N camera, the following buttons on the AW-RP555 will not work. 1/120 1/250 PRESET2 PRESET3 --SYNCHRO PRESET7 PRESET8 • WHITE BAL A/B/ATW • SCENE FILE 3 1/500 1/1000 PRESET4 PRESET5 --OFF PRESET9 PRESET10 *1: The lamp of the ABB or AWB switch flashes while automatic white balance or automatic black balance is being executed, respectively. When ABB or AWB is completed successfully, the corresponding lamp goes off; when it is not completed successfully, it lights up. When the AK-HC1800N, to which the motor drive lens is connected, has been directly connected to the AW-RP555 controller, zooming and focusing can be controlled using the controller's joystick.  When changing the panel display for use with the AK-HC1800N, please use panel sheet VGKB0006 (sold separately as a replacement part). Ver.041 or a subsequent version of the AW-RP555 software must be installed in order for the AK‑HC1800N to be controlled using the AW-RP555. To check the software version of your AW-RP555, contact your dealer. - 20 -