Panasonic BLPA300A BLPA300A User Guide - Page 13
Placing the adaptors, Power Save Mode
UPC - 037988845569
View all Panasonic BLPA300A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Installation Placing the adaptors Refer to the information on page 5 when selecting a location to place your adaptors. Note • If you have purchased additional adaptors, make sure you have registered them to the master (see page 11) before placing them where you plan to use them. 1. Connect the adaptor to a wall outlet in the room where you plan to use it. 2. Confirm that the PLC indicator of each adaptor lights in green when you plug the adaptors into the wall outlets. • If the PLC indicators do not light in green, see page 19. After you have plugged the adaptors into the wall outlets in the rooms where you plan to use them, test the terminal's network speed (see page 15). Power Save Mode If a terminal's LAN port is inactive for more than 20 minutes (i.e., if its LAN indicator is orange for more than 20 minutes), the terminal automatically enters Power Save mode, and its power consumption is reduced. While in Power Save mode, the adaptor's LAN indicator is turned off. Power Save mode is only activated for terminal adaptors that are linked to the HD-PLC network. PLC LAN MASTER PLC LAN MASTER BL-PA300 HD-PLC PLC LAN MASTER SETUP (green) (orange) about 20 minutes later BL-PA300 HD-PLC PLC LAN MASTER SETUP (green) Terminal Adaptor Power Save Mode Power Save is deactivated when: - An active network device is connected to the terminal. - A network device connected to the terminal is turned on. - The adaptor's SETUP button is pressed. [For assistance, please call: 1-800-272-7033] 13