Panasonic DMP-BD81 DMP-BD81 Owner's Manual (English) - Page 27

Tr Reference oubleshooting guide Before requesting service, please perform the following steps. ∫ Unit does not respond to remote control or unit's buttons. Disconnect AC power supply cord, wait 1 minute, then reconnect AC power supply cord. Do you have the latest firmware installed? Panasonic is constantly improving the unit's firmware to ensure that our customers are enjoying the latest technology. (> 12) 4 Make the following checks and visit our website for more information. For U.S.A. : www.panasonic.com/support Enter the model number. For Canada : http://www.panasonic.ca 4 Or visit our website to find a service center. You can find a service center near you easily on our website. Other support information: "Customer Services Directory (United States and Puerto Rico)" (> 33) or "CONTACT INFORMATION" (> 34). The following do not indicate a problem with this unit: - Regular disc rotating sounds. - Image disturbance during search. ∫ Cannot eject disc. 1 Turn the unit on. 2 Press and hold [OK], the yellow button and the blue button on the remote control at the same time for more than 5 seconds. - POWER LED starts to flash, and "00RET" is displayed on the screen. 3 Press [1] (right) repeatedly on the remote control until "06FTO" is displayed on the screen. 4 Press [OK]. General operation To return to the factory defaults. ¾ Select "Yes" in "Restore Default Settings" in the Setup menu. (> 26) To return all settings to the factory preset. ¾ Reset the unit as follows: 1 Turn the unit on. 2 Press and hold [OK], the yellow button and the blue button on the remote control at the same time for more than 5 seconds. - POWER LED starts to flash, and "00RET" is displayed on the screen. 3 Press [1] (right) repeatedly on the remote control until "08FIN" is displayed on the screen. 4 Press and hold [OK] for more than 5 seconds. The remote control does not work properly. ¾ Change the batteries in the remote control. (> 5) ¾ The remote control and this unit are using different codes. Turn on this unit by using the standby/on switch on this unit, and check "Remote control " which is displayed on the screen when you press a button on the remote control. Press and hold [OK] and the displayed number ("") for at least 5 seconds. The TV tuner mode is not displayed when the TV is turned on. ¾ This phenomenon may occur, depending on the TV setting, when "Quick Start" is set to "On". ¾ Depending on the TV, this phenomenon may be prevented by reconnecting the HDMI cable to a different HDMI input terminal or by changing the HDMI auto connection setting. You have forgotten your ratings password. You want to cancel the ratings level. ¾ The ratings level returns to the factory defaults. 1 Turn the unit on. 2 Press and hold [OK], the yellow button and the blue button on the remote control at the same time for more than 5 seconds. - POWER LED starts to flash, and "00RET" is displayed on the screen. 3 Press [1] (right) repeatedly on the remote control until "03 VL" is displayed on the screen. 4 Press [OK]. Settings Reference 27 SQT0108