Panasonic KX-TG2352W 2.4 Ghz Cordles Phon - Page 44

Voice Mail Service Setting the Voice Mail (VM) Tone Detection Your telephone company sends special signals (Voice mail tones) to activate the voice mail display. Press or to listen to the dial tone. If you hear a series of dial tones followed by a continuous dial tone, this is indication that a new message was recorded. Your phone comes set to detect these tones (set to "On"). Minutes after you hang up or after the phone stops ringing, your unit will seize the phone line and check if a message has been recorded. If a new message was recorded at your telephone company, "Voice mail" will be displayed on the handset. Set this programming to "Off" when: -you do not subscribe to a voice mail service, -your telephone company does not send a series of tones, followed by a continuous tone, or -your phone is connected to a business or office telephone system (PBX). Please refer to below to set this programming to OFF. If you are not sure which setting is required, consult your local telephone company or contact Panasonic Customer Call Center. Make sure the unit is not being used and the handset is lifted off the base unit. 1 Press (MUTE/FUNCTION) and scroll to "Initial set" by pressing Ö or Ñ, and press á. Ringer setting HInitial set 2 Scroll to "Voice mail" by pressing Ö or Ñ, and press á. 3 Press á at "VM tone detect". •The current setting is displayed. 4 Select "On" or "Off" by pressing Ö or Ñ. 5 Press á (Save key). •A beep sounds. •To exit the programming mode, press (OFF). Set tel line HVoice mail HS register HVM tone detect Save VM acces# VM tone detect :On GF H=Save VM tone detect :On •You can exit the programming mode any time by pressing (OFF). 44