Panasonic KX-TG2352W 2.4 Ghz Cordles Phon - Page 58

Troubleshooting Problem Cause & Remedy The unit does not work. •Check the settings (p. 8-10). •Check whether the dialing mode setting is correct (p. 14). •Charge the battery fully (p. 9, 10). •Clean the charge contacts and charge again (p. 10). •Install the battery properly (p. 9). •Unplug the AC adaptor of the base unit to reset. Plug in, and try again. •The handset has not been registered to the base unit. Register the handset (p. 19, 55). •Re-install the battery (p. 53) and charge it fully. "No link to base Move closer to base, try again" is displayed and an alarm tone sounds. •You are too far from the base unit. Move closer to the base unit and try again. •Plug in the AC adaptor of the base unit. •Raise the base unit antenna. Static, sound cuts in/out, fades. Interference from other electrical units. •Locate the handset and the base unit away from other electrical appliances (p. 3). •Move closer to the base unit. •Raise the base unit antenna. The handset does not ring. •The ringer volume is OFF. Set to HIGH or MEDIUM or LOW (p. 17). •While you are making an intercom call, these handsets do not ring. Instead users will hear incoming call tones (p. 49). The handset display is blank. •Charge the battery fully (p. 9, 10). 58