Panasonic P2 Handheld Camcorder Basic Operating Instructions - Page 21

Power sources, Using the battery, Using the AC adaptor, Installation, Removal

Get Panasonic P2 Handheld Camcorder PDF manuals and user guides View all Panasonic P2 Handheld Camcorder manuals
Add to My Manuals
Save this manual to your list of manuals

Page 21 highlights

Power sources Using the battery Installation Insert the battery until it clicks into place. Removal 1 Set the POWER/MODE switch to OFF, and check that the mode lamp is off. (Page 25) 2 While pressing the battery release button, raise up the battery to remove it. • Support the battery with your hand to ensure that it will not fall. Preparation Mode lamps Battery release button Using the AC adaptor Installation 1 Insert the DC cable's battery connector until it clicks into place. 2 Connect the AC power supply cable. Connect the AC power supply cable in the order 1 and 2. DC cable's battery connector Insert it all the way in. 1 2 Removal 1 Set the POWER/MODE switch to OFF, and check that the mode lamp is off. (Page 25) 2 Remove the DC cable's battery connector while pressing the battery release button. 3 Disconnect the AC power supply cord from the power outlet. • Disconnect the AC power supply cable from the power outlet when the unit is not going to be used. • When the AC power supply cable is disconnected from the power outlet, the power lamp on the AC adaptor remains lit for a while then shuts off. This is not a malfunction. 21

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
21
Preparation
Power sources
Using the battery
Installation
Insert the battery until it clicks into place.
Removal
1
Set the POWER/MODE switch to OFF, and
check that the mode lamp is off.
(Page 25)
2
While pressing the battery release button,
raise up the battery to remove it.
•
Support the battery with your hand to ensure
that it will not fall.
Mode lamps
Battery release button
Using the AC adaptor
Installation
1
Insert the DC cable’s battery connector
until it clicks into place.
2
Connect the AC power supply cable.
Connect the AC power supply cable in the
order
1
and
2
.
1
2
DC cable’s
battery connector
Insert it all the
way in.
Removal
1
Set the POWER/MODE switch to OFF, and
check that the mode lamp is off.
(Page 25)
2
Remove the DC cable’s battery connector
while pressing the battery release button.
3
Disconnect the AC power supply cord from
the power outlet.
•
Disconnect the AC power supply cable from
the power outlet when the unit is not going to
be used.
•
When the AC power supply cable is
disconnected from the power outlet, the power
lamp on the AC adaptor remains lit for a while
then shuts off. This is not a malfunction.