Panasonic P2 Handheld Camcorder Basic Operating Instructions - Page 24

The remote control Insert the battery 1 Push the catch in the direction shown by arrow 1 to remove the holder. 2 Insert the battery with the "+" marked side facing up. 3 Return the holder to its original position. • When the battery (CR2025) has run out, replace it with a new one. (The battery lasts about one year, depending on the frequency of use.) If the remote control unit fails to work even when it is operated near the camera-recorder's remote control sensor, the battery has run out. • Keep the battery out of the reach of children. Remote control setup When using two camera-recorders simultaneously, set this camera-recorder and the remote control to either "operation mode 1" or "operation mode 2" so the remote control does not operate the wrong camera-recorder by mistake. Setting • Wireless remote control Press the operation buttons STOP () and STILL ADV ( ) at the same time to set the remote control unit for use in "operation mode 1". Alternatively, press the STOP () and STILL ADV ( ) buttons at the same time to set the remote control unit for use in "operation mode 2". When the battery in the remote control unit is replaced, the remote control unit is set for use in "operation mode 1". • Camera-recorder In the setup menus, OTHER FUNCTIONS screen, REMOTE, set to 1 or 2. (Page 151 of Vol. 2) If different settings are used for the camerarecorder and remote control unit, "REMOTE" lights in red on the viewfinder and LCD monitor. Operation mode 2 Operation mode 1 24