Panasonic SCHTB170 SCHTB170 User Guide - Page 24

Bluetooth® communication mode You can select different modes to suit the type of connections with emphasis on connectivity or high quality audio. ≥ Make sure that a Bluetooth® device is already paired with this system. (> 19) Press [ ] to select " ". ≥ " " indicator will blink slowly. If the indicator lights, a Bluetooth® device is already connected with this system. Disconnect it. (> 19) Press [ ] to display the current mode. "STANDARD" indicator blinks: MODE1 (Factory preset) Emphasis on connectivity "STEREO" indicator blinks: MODE2 Emphasis on audio quality While the mode is displayed, press [ ] to select the mode. ≥ The setting changes each time [ ] is pressed. ≥ The indicator for the selected setting blinks for 10 sec and then exits the setting mode. ≥ The setting is maintained until it is changed again. Using the Dolby Virtual Speaker effect Depending on your preference, It is possible to turn off the 3D surround effect and the clear-mode dialog effect. While pressing and holding [SOUND] on the remote control, press and hold [VOL i] on the main unit for more than 4 sec. "STANDARD" indicator blinks: 3D surround effect and clear-mode dialog effect is on. "STEREO" indicator blinks: 3D surround effect and clear-mode dialog effect is off. While the setting is displayed, press [SOUND] to change the setting. ≥ The setting changes each time [SOUND] is pressed. ≥ The indicator for the selected setting blinks for 20 sec and then exits the setting mode. ≥ This setting will be reset to on when the main unit is turned off. ≥ When off is selected, the dialog effect level cannot be adjusted. Dimmer mode You can turn off dimmer mode and keep the LED indicators bright. While pressing and holding [INPUT SELECTOR] on the remote control, press and hold [s VOL] on the main unit for more than 4 sec to turn off Dimmer mode. ≥ The indicator for the current condition will turn brighter. ≥ The setting is maintained until it is changed again. ≥ Default setting of this function is on. To turn on dimmer mode, repeat the operation above. After performing the operation, the indicator for the current condition will be dim. 24 RQT9841