Panasonic SXKN7000 SXKN7000 User Guide - Page 130
Saving data
View all Panasonic SXKN7000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 130 highlights
Disk Drive Part VI Disk Drive Saving data The recorded data and panel settings of this instrument can be saved on a disk. Disks You can use 3.5 inch 2DD (720KB) or 2HD (1.44MB) disks. • How to distinguish the two disk types: 2DD 2HD • When saving data to the disk, the write-protect tab must be closed. Storage is not Storage is possible possible No hole Hole • Although 2HD disks can hold more data and are convenient for quick loading and saving, some models may be able to read only 2DD disks. Therefore, you may not be able to use your 2HD disk data with other musical instrument models. FORMAT Disks which are used for the first time with this instrument have to be formatted through the following procedure. When an unformatted disk is inserted into the Disk Drive slot and you attempt to execute the save or load procedure, the DISK FORMAT display appears. Follow the instructions shown to format the disk. • Note that this procedure clears any data which is currently stored on the disk. 1. Select the type of format (2DD or 2HD). • Be sure to select the type which is the same as your disk type. • If the type is automatically detected, the display changes directly to the following display, without showing the type select display. • The display looks similar to the following. • If you wish to select the type again, use the PAGE button to access the PAGE 2/2 display. Open Closed 2. Press the YES button to format the disk, or press the NO button to cancel the format. • When the YES button is pressed, disk format begins. After about 1- 2 minutes, formatting is completed and DISK NAMING display is shown. 3. Use the buttons below the display to assign a name. • Press a button for the corresponding letter. Press the SHIFT button to display numbers. • Press the POSITION button to move the cur- sor. • You can also use the TEMPO/PROGRAM dial to select the characters. • Press the INS button to enter a space at the cursor position. • Press the DEL button to erase the character at the cursor position. • Press the CLR button to erase the entire name. • Press the →← button to center the name. 4. Press the OK button. • The FORMAT display can also be accessed from the DISK TOOLS menu when, for example, you wish to reformat a disk. (Refer to page 135.) 130 QQTG0671