Panasonic TH-55LFE8U Professional Display for Simple Entry-Level Digital Signage - Page 25

Basic Controls AC socket outlet AC cord (supplied) 43/48/55-inch models Remote Control Sensor/ Power Indicator 65-inch model Main Power On / Off switch (Back of the unit) Remote Control Sensor/ Power Indicator Operate pointing the remote control directly at the unit's Remote Control Sensor. 1 Connect the AC cord plug to the Display. (see page 13) 2 Connect the plug to the socket outlet. Note Ɣ Main plug types vary between countries. The power plug shown at left may, therefore, not be the type fitted to your set. Ɣ When disconnecting the AC cord, be absolutely sure to disconnect the AC cord plug at the socket outlet first. 3 Press the on the unit to turn the set on: Power-On. Ɣ Power Indicator: Green (Picture is displayed.) Ɣ When the power of the unit is ON, remote control operation is possible. Ŷ To turn the power ON/OFF with the remote control Press the standby (ON/OFF) button to turn the Display on. Ɣ Power Indicator: Green (Picture is displayed.) Press the standby (ON/OFF) button to turn the Display off. Ɣ Power Indicator: Red (standby) Press the on the unit to turn the unit off, when the power of the unit is turned on or in standby mode. Note Ɣ During operation of the "Power management" function, the power indicator turns orange in the power off state. "Power management" function (see page 51) Note Ɣ For normal use, pull out the remote control sensor from the edge side of the main unit by operating the lever on the rear panel. (see page 23) Ɣ Do not put an obstacle between the remote control sensor of the main unit and the remote control. Ɣ Operate the remote control in front of the remote control sensor or from the area where the sensor can be seen. Ɣ Do not subject the remote control sensor of the main unit to the direct sunlight or strong fluorescent light. English 25