Panasonic TH42PWD6UX TH37PWD6UX User Guide - Page 10
Pc Input Terminals Connections
View all Panasonic TH42PWD6UX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Connections PC Input Terminals connection COMPUTER AUDIO PC IN Conversion adapter (if necessary) R - STANDBY G POWER ON Less than 3" 15/16 (10 cm) - + INPUT MENU VOL ENTER Ferrite core (large size) (supplied) D-sub 15p RGB PC cable Ferrite core (small size) (supplied) Less than 3" 15/16 (10 cm) Audio Stereo plug Connect a cable which matches the audio output terminal on the computer. Installing the ferrite core (Small size) 1 2 3 Open Pull back the tabs (in two places) Press the cable through and close Installing the ferrite core (Large size) 1 2 3 Open Pull back the tabs (in two places) Press the cable through and close Notes: (1) Computer signals which can be input are those with a horizontal scanning frequency of 15 to 110 kHz and vertical scanning frequency of 48 to 120 Hz. (However, the image will not be displayed properly if the signals exceed 1,200 lines.) (2) The display resolution is a maximum of 640 × 480 dots when the aspect mode is set to "4:3", and 852 × 480 dots when the aspect mode is set to "16:9". If the display resolution exceeds these maximums, it may not be possible to show fine detail with sufficient clarity. (3) The PC input terminals are DDC1/2B-compatible. If the computer being connected is not DDC1/2B-compatible, you will need to make setting changes to the computer at the time of connection. (4) Some PC models cannot be connected to the set. (5) There is no need to use an adapter for computers with DOS/V compatible D-sub 15P terminal. (6) The computer shown in the illustration is for example purposes only. (7) Additional equipment and cables shown are not supplied with this set. (8) Do not set the horizontal and vertical scanning frequencies for PC signals which are above or below the specified frequency range. (9) Component Input is possible with the pin 1,2,3 of the D-sub 15P Connector. Signal Names for D-sub 15P Connector 11 12 13 14 15 6 7 8 9 10 12345 Pin Layout for PC Input Terminal Pin No. 1 2 3 4 5 Signal Name R (PR/CR) G(Y) B(PB/CB) GND (Ground) GND (Ground) Pin No. Signal Name Pin No. 6 GND (Ground) 11 7 GND (Ground) 12 8 GND (Ground) 13 9 NC (not connected) 14 10 GND (Ground) 15 Signal Name GND (Ground) SDA HD/SYNC VD SCL 10