Panasonic TH42PWD6UX TH37PWD6UX User Guide - Page 9

Connections

Page 9 highlights

Connections When connecting the speakers, be sure to use only the optional accessory speakers. Refer to the speaker's Installation Manual for details on speaker installation. Speakers (Optional accessories) 1 2 1 SPEAKERS Terminals (R) SPEAKERS Terminals (L) AC cord connection (see page 12) - AC cord fixing 1. Open the clamper. 2. Insert the AC cord and close the clamper securely. 2 3. Slide up the clamper and fix the AC cord plug securely. When loosen the clamper: Clamper AC cord Note: The power plug in the illustration may not be the type fitted to your set. - Cable fixing bands Secure any excess cables with bands as required. Pass the attached cable fixing band through the clip as shown in the figure. To secure cables connected to Terminals, wrap the cable fixing band around them then pass the pointed end through the locking block, as shown in the figure. While ensuring there is sufficient slack in cables to minimize stress (especially in the power cord), firmly bind all cables with the supplied fixing band. To tighten: To loosen: Push the Pull catch 1 2 Pull Optional Terminal Board insert Slots (covered) SLOT1 SLOT2 AUDIO PC IN SERIAL SLOT3 From EXTERNAL monitor terminal on Computer (see page 10) From SERIAL Terminal on Computer (see page 11) 9

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40

9
1
2
SERIAL
PC
IN
AUDIO
1
2
1
2
Connections
SPEAKERS
Terminals (R)
SPEAKERS
Terminals (L)
– Cable fixing bands
Secure any excess cables with bands as required.
When connecting the speakers, be sure to use only the optional accessory speakers.
Refer to the speaker’s Installation Manual for details on speaker installation.
Speakers (Optional accessories)
Pass the attached
cable fixing band
through the clip as
shown in the figure.
To secure cables connected to Terminals, wrap the cable fixing band
around them then pass the pointed end through the locking block, as
shown in the figure.
While ensuring there is sufficient slack in cables to minimize stress
(especially in the power cord), firmly bind all cables with the
supplied fixing band.
AC cord connection (see page 12)
To tighten:
To loosen:
Pull
Pull
Push the
catch
3.
Slide up the clamper and fix
the AC cord plug securely.
2.
Insert the AC cord and
close the clamper
securely.
1.
Open the clamper.
Clamper
AC cord
Note:
The power plug in the illustration may not be the type fitted to your set.
When loosen
the clamper:
– AC cord fixing
From EXTERNAL monitor terminal
on Computer (see page 10)
Optional Terminal Board insert Slots (covered)
From SERIAL Terminal on
Computer (see page 11)
SLOT1
SLOT2
SLOT3