Pentax IQZoom 80G IQZoom 80G Manual - Page 29
Correcting
View all Pentax IQZoom 80G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
Correcting the date 1. Depress the SELECT button to make a different category of digits on the LCD panel that you want to change blink. 2. Depress the ADJUST button 0 to change digits of the specified category you chose with the SELECT button. Digits increase by one each time you depress the ADJUST button 0. Holding down the button will advance digits continuously. 3. After the data has been adjusted, depress the SELECT button 0 each time until blinking stops. • Depress the SELECT button peach time. The bar mark ( - ) appears on the LCD panel, indicating that data imprinting choices are possible. • The blinking " : " allows precise fine-tuning of the internal clock to the beginning of a specified minute. To do so, depress the DATE button 0 until "Day-Hour-Minute" digits appear and then depress the SELECT button 0 to make the " : " blink. Then depress the ADJUST button 0 in sync with a time signal. • If you release the shutter while the blinking data is being corrected, the data cannot be imprinted. Operational precautions The data on the LCD panel is imprinted on each frame you expose. • "Year-Month-Day" and "Day-Hour-Minute" cannot be imprinted at the same time. • As you release the shutter, the bar( - ) mark on the display blinks for a few seconds, indicating the data has been imprinted. • If there is a white or yellow object in the corner of the picture where the data is imprinted, the data may be difficult to read. When composing your photographs, try to avoid brightly-colored subjects in that corner. A -e * The date in the picture above is simulated. 25