Pfaff 1211 Owner's Manual - Page 4

To remove the bobbin case ... 6 Make sure the needle is positioned above the needle plate. On the Pfaff 1211 remove the bed cover. Lift latch K (see ill.) and pull out the bobbin case with the bobbin. The bobbin cannot fall out as long as you hold the bobbin case by its open latch. When you release the latch, the empty bobbin drops out. On the Pfaff 1212 open the free-arm cover and swing It toward the left. Then - just tiko with the Pfaff 1211 - lift latch K and pull out the bobbin case with the bobbin. MIL rPFAFF) 1212 .... and to wind the bobbin Raise both spool pins and place a spool of thread on one of them. Place the bobbin on bobbin winder disc s where it is held in position magnetically (see illustration at left). Pass the thread from the spool to the bobbin. as shown in the above illustration. toward you. Start the bobbin winder by pressing down on the foot control. The bobbin winder stops automatically when the bobbin is full. To re-engage the sewing mechanism after bobbin winding, turn the stop motion knob in the balance wheel (7) away from you. The sewing mechanism is re-engaged automatically on starting the machine. Wind the thread clockwise around the bobbin a few times. Push lever E against the bobbin, hold the balance wheel, and turn the stop motion knob 7