Pfaff expression 3.0 Owner's Manual - Page 17
Bobbin winding
View all Pfaff expression 3.0 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Preparations C Bobbin winding Winding from horizontal position 1. Place an empty bobbin on the bobbin spindle, with the logo facing up. Use only the original PFAFF® bobbins approved for this model. 2. Place the thread spool on the spool pin in horizontal position. Slide a spool cap tightly against the spool. 3. Place the thread into the thread guide (A) from front to back. Pull the thread counter-clockwise above the bobbin winder thread guide (B) and then through the bobbin thread guides (C) at the rear. Note: Make sure the thread is pulled securely inside the pre-tension device for correct thread tension. 4. Thread through the hole in the bobbin (D) from the inside to the outside. 5. Push the bobbin lever to the right to wind. A pop-up appears on the screen to inform you that bobbin winding is active. Press the foot control to start winding the bobbin. When the bobbin is full, the bobbin winding will slow down and stop automatically. The pop-up closes. Remove the bobbin and cut the thread using the bobbin thread cutter (E). Winding through the needle Make sure that the presser foot and the needle are in the up position. Only wind through the needle if using a metal presser foot. Bring the thread up from the needle, under the presser foot, upward through the left-hand threading slot and through the bobbin thread guides (C). Then follow step 4 and 5 above. C E B C A D B C A 2:5