Philips 32PF5320A Quick Use Guide - Page 2

CONNECTING PERIPHERAL EQUIPMENT TO THE LCD TELEVISION CABLE/CABLE BOX TV Your Cable TV input into your home may be a single (75 ohm) cable or use a cable box decoder. In either case the connection is very simple. Follow the steps below to connect your cable signal to your new television. Direct Cable Connections: This connection will supply Stereo sound to the TV. 1 Connect the open end of the round Cable Company supplied cable to the 75Ω input on the bottom of the TV. Direct Cable Connection: Jack Panel Bottom of TV Cable signal coming from Cable Company (Round 75Ω coaxial cable) 1 Cable Box (w/RF In/Outputs): This connection will NOT supply Stereo sound to the TV. The sound from the cable box will be mono. Cable Box with RF Inputs and Outputs Connection: Output Channel Switch 1 Connect the open end of the round Cable Company supplied cable to the cable signal IN(put) plug on the back of the Cable 1 Box. 2 Using a separate round coaxial cable, connect one end to the OUT(put) (TO TV) plug on the back of the Cable Box. 3 Connect the other end of the round coaxial cable to the 75Ω input on the bottom of the television. 2 Jack Panel Back of Cable Box NOTE: Be sure to set the OUTPUT CHANNEL SWITCH on the back of the cable box to CH 3 or 4, then tune the cable box on the TV to the corresponding channel. Once tuned, change channels at the cable box, not the television. Cable Signal IN from the Cable Company Round 75Ω Coaxial Cable Jack Panel Bottom of TV 3 Cable Box (w/Audio/Video Outputs): This connection will supply Stereo sound to the TV. 1 Connect the open end of the round Cable Company supplied cable to the cable signal IN(put) plug on the back of the Cable Box. 2 Using an RCA type Video Cable, connect one end of the cable to the Video (yellow) (or ANT, your cable box may be labeled differently) Out jack on the cable box and the other end to the Video In jack on the bottom of the TV. 3 Using an RCA type Audio Left and Right Cable, connect one end to the left and right Audio Out L & R jacks (red & white) on the cable box and the other ends to the Audio In L & R jacks on the bottom of the TV. NOTE: Use the AV button and the CURSOR DOWN/RIGHT on the TV remote control to tune to the AV channel for the cable box signal. Once tuned, change channels at the cable box, not the television. Cable Box with Audio/Video Outputs Connection: 1 Cable Signal IN from the Cable Company Jack Panel Back of Cable Box with A/V Outputs 2 3 Audio Cables L & R (Red, White) Video Cable (Yellow) Jack Panel Bottom of TV 2