Philips 46PFL3608 User manual - Page 76
Use your TV, Switching on your TV and putting it in Standby mode, Adjusting Volume, Switching Channels
View all Philips 46PFL3608 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 76 highlights
4 Use your TV Switching on your TV and putting it in Standby mode TV * Key on Rear Remote Control Switching Channels TV * Key on Rear Remote Control 20 .English To Turn the TV On from Standby or Off to Standby ● Press B on the Rear panel or the Remote Control. Note(s) ● Energy Consumption contributes to air and water pollution. When the AC Power Cord is plugged in, your TV consumes energy with a very low standby Power Consumption. Adjusting Volume TV * Key on Rear Remote Control To select Channels by using CH H / I or CH + / - ● Press CH H (Up) / I(Down) on the Rear panel or press CH + / - on the Remote Control. To select Channels by using the NUMBER buttons Digital TV Operation ● For Digital channels, press a number followed by a dot "•" and the corresponding sub channel number. - When selecting Digital channel 11.1 Be sure to press • before entering the subchannel number. To decrease or increase Volume ● Press VOL J / K on the Rear panel or press VOL + / - on the Remote Control. VOL J (-) : Volume Down VOL K (+) : Volume Up To mute or unmute sound ● Press V on the Remote Control to mute the sound. ● Press V again or VOL + / - to recover the original sound. Cable / NTSC (Analog) TV Operation - When selecting Cable or Analog channel 11 Press PREV.CH to return to the previously viewed channel. Note(s) ● To select the non-memorized channels, use the NUMBER buttons. ● Channel not available or No Signal will appear on the TV screen after the subchannel broadcast is over. ● Audio Only message will appear on the TV screen, when you receive only sound signal. * All CONTROL Keys are located on the Rear (lower right) side of the unit as viewed from the Front.