Philips DCM109 User manual - Page 14

4 Get started Caution • Use of controls or adjustments or performance of procedures other than herein may result in hazardous radiation exposure or other unsafe operation. Always follow the instructions in this chapter in sequence. If you contact Philips, you will be asked for the model and serial number of this apparatus.The model number and serial number are on the rear of the apparatus.Write the numbers here: Model No Serial No Prepare the remote control Caution • Risk of explosion! Keep batteries away from heat, sunshine or fire. Never discard batteries in fire. 3 1 2 1 Open the battery compartment. 2 Insert 2 AAA batteries (not supplied) with correct polarity (+/-) as indicated. 3 Close the battery compartment. Note • If you are not going to use the remote control for a long time, remove the batteries. • Do not use old and new or different types of batteries in combination. • Batteries contain chemical substances, so they should be disposed of properly. • Perchlorate Material - special handling may apply. See www.dtsc.ca.gov/hazardouswaste/ perchlorate. Plug & Play When you connect the unit to the power supply for the first time, or no radio station is stored in this unit, Plug and Play mode is activated to store all available radio stations automatically. 1 Connect the unit to the power supply. » [AUTO INSTALL - PRESS PLAY, STOP CANCEL] (auto install - press the PLAY button; to cancel, press ) displays. 2 Press on the main unit to start installation. » [AUTO] (auto) displays. » [PROG] (program) flashes. » The unit automatically store radio stations with sufficient signal strength. 3 When all the available radio stations are stored, the first preset radio station is broadcast automatically. Tip • If no key is pressed during Plug and Play mode, the system goes to Standby mode after timeout of 5 times. To go to installation again, press and hold for 3 seconds under Standby mode. Toexit Plug and Play installation mode 1 press source keys or on the remote control. 14 EN